Taillight fittings

[EKSPCL]

When I got the EK she was partially disassembled.

Some of the parts I don't seem to have are the all the wires/plugs that go to the taillights, rear indicators and reverse lights.

The globes fit in from behind the lenses, but I can't find any pics in the manual, or on here, of the plug that goes in from the wiring side

I have found the fittings for my front indicators at Autobarn.

Hands up who can help

[jack_fc]

check the thread in 'electrical' - 'indicators' by FBVAN; if EK fittings are same as FC, these are them . look at the Narva site under 'globe holders', I think you can get the metal-bodied globe holders to suit either single or dual filament globes
hope this helps, jack

[EKSPCL]

Thanks Jack.
I found the front indicators thanks to your help on my other post.

I can't work out if any of the plugs on the Narva site will fit the taillights though.....

http://www.narva.com.au/products/browse/globe-holders

This is what I have........


If the fitting is one of the ones on the above Narva site, which one?
Forgive me if I'm not seeing something obvious

[Blacky]

The rest of the fitting should be on your wiring harness.

[EKSPCL]

No, that's my problem.

The guy who I got the car off has cut the wiring off the loom from the dash

I have had to re-do the wiring from the dash.

I haven't ever seen the plugs to know what they should look like

[jack_fc]

EKSPCL, sorry mate, cant help with that one... it's obviously different to FE/FC taillights

[fj_225]

hi ekspcl.i have a old loom here if its any good to you cheers shane

[EKSPCL]

PM sent.

Thanks

[EKSPCL]

I've found one brake light fitting and the two indicators. Thanks again Shane

Now I know what they look like.....



I need another brake/tail light fitting and the two reverse light fittings.

I'll put this to the Parts Wanted section now.

Thanks for the help