Anyone wrecking a ute?

[Brett027]

Great work. Where did the square stampings appear from?

[oz_ek]

Great work. Where did the square stampings appear from?

I asked the same question and suggested it only needed to be as per original with the swage lines in pairs.....Mark said his design is stronger.

[Brett027]

Yes, no doubt it would be. Good on him for doing it.

[oz_ek]

I'm after that same section.

Let me know if you're still looking for the upper panel?

[vmx-mxr]

Yes Please
I think the amount of stretching may be a challenge to remove as all the beads are well bent as well
I saw the Childers ute but not sure how you would go about getting the cut sent to Sydney?

[gpi]

not bad but you can tell which bead rolling has been done after smoko

https://www.facebook.com/marketplace/it ... 1744723998

[oz_ek]

not bad but you can tell which bead rolling has been done after smoko

https://www.facebook.com/marketplace/it ... 1744723998

Looks like the listing was removed or sold?

[Blacky]

perfect timing, for sale on bookface


Sent from my iPhone using Tapatalk

[gpi]

yeah its been posted to a couple of groups, not keen on all the extra panel work, looks like its going to a dippity-doo convention

[Blacky]

yeah its been posted to a couple of groups, not keen on all the extra panel work, looks like its going to a dippity-doo convention

Meh - nobody will see it down there - hopefully these being early iterations the quality will pick up a bit . He must be rolling them in stages rather than them being pressed as they would have been back in the day.

[gpi]

i guess the uniqueness negates the cease and desist letters

[admin_maintenance]

I have been to Marks place in Traralgon about a week ago. Im building my modified FJ van at a mates on Traralgon. He works from home and is making it all from there. It appears to me he is just making miscellaneous bits and pieces for utes and vans

Im down in Traralgon most weekends working on my van and would be happy to pick anything up for anyone and cart back to Melbourne.

[admin_maintenance]

yeah its been posted to a couple of groups, not keen on all the extra panel work, looks like its going to a dippity-doo convention

Meh - nobody will see it down there - hopefully these being early iterations the quality will pick up a bit . He must be rolling them in stages rather than them being pressed as they would have been back in the day.

Yep mate he is bead rolling them.