Trim clips and end bits

[steveo]

Hi ,
Isolating in the garage for the next couple of weeks so may finally make some progress..
Looking for advice on stainless trim attachment . I have clips from rare s , but they don't seem to be a good fit. Quite possible it is operator error .
Do you just give it a whack ?
And what is the end clip... larger hole //?

Advice appreciated

Thanks ,

Steveo

[funkyscooter]

I got these after guessing from what was left on the car - don't know what was holding the trim on.

IMG_8721.JPG (603.04 KiB) Viewed 565 times

Look a bit large as its closer to the camera. Not sure if they will work, and a long way off finding out

[steveo]

Thanks , I have some of those and my best guess at fitting is as picture ..
. it doesn't seem very robust..

[Errol62]

The ones on your car look about right to me Stevo, but I’m no expert on Specials. I was going to get the ones Scott posted to fit the commercial/standard guard spears as I reckon they matched the originals on mine. Ended up re using original ones in the end.


FB ute fixer upper, EK van on rotisserie

[Blacky]

That looks about right

[steveo]

Thanks .. all good

[In the Shed]

good job

[Errol62]

Second that. Looks very straight.


FB ute fixer upper, EK van on rotisserie