Page 1 of 1
4 speed to auto
Posted: Sat Oct 24, 2009 9:27 pm
by FantaC
Was thinking about putting a trimatic auto into my EH
it has an all Aussie 4 speed at the moment so will the auto fit ?
will i have to change the tail shaft ?
crossmember too ?
im only driving a EH till i get a FB-EK
Cheers John
Posted: Sun Oct 25, 2009 12:02 am
by Blacky
Yep , piece a cake mate, just need the right auto (shifter on the right hand side) and its virtually a bolt in job. I have quite a few of the bits you will need - will talk tomorrow.
Posted: Sun Oct 25, 2009 7:58 am
by FB MAD
Remember reading a fair bit on conversions on an EJ/EH forum a while back ??
Google EJ/EH forum or similar keywords and it might come up??
Posted: Sun Oct 25, 2009 8:05 am
by FB MAD
Posted: Sun Oct 25, 2009 8:09 am
by FB MAD
Posted: Sun Oct 25, 2009 8:42 am
by FantaC
thanks guy`s
Posted: Sun Oct 25, 2009 8:45 am
by mrs ratbox
like blacky said all you need is the actual parts associated with the auto ie box, converter, flexplate, bolts, shift. crossmember, tailshaft identical
Posted: Sun Oct 25, 2009 4:15 pm
by FantaC
Thanks RatBox
have everything but a shifter even have an auto radiator but might get a seperate oil cooler
Spewing cos i replaced the steering colum with an auto colum but i cut the gear lever of and gutted it , so will just settle for a T bar type
or could i fit a manual gear selecter with the auto colum setup ?
Posted: Sun Oct 25, 2009 8:28 pm
by Devilrod
Don't forget to remove the spigot bearing either...
Posted: Sun Oct 25, 2009 8:40 pm
by FantaC
thanks DevilRod
Posted: Mon Oct 26, 2009 1:06 pm
by Sammy
Devilrod wrote:Don't forget to remove the spigot bearing either...
and put the auto spigot in there!
Posted: Mon Oct 26, 2009 5:36 pm
by FantaC
Thanks Sammy
