Hi Everyone,
Is anyone running 13x6 rims and with a 3" drop?
Completely stock front end and rear end but with heavy duty lowered front springs and reset rear leaves.
Any issues for a NSW rego with this setup?
regards
Stewart
Anyone running 13x6s?
-
parisian62
- Posts: 3997
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
Anyone running 13x6s?
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
-
mrs ratbox
-
parisian62
- Posts: 3997
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
its a blue slip RB...planning ahead for the wagon...
Is anyone running 13x6's rims...? Would they bolt straight on? Would there be any clearance issues with guards or rear quarters?
Is anyone running 13x6's rims...? Would they bolt straight on? Would there be any clearance issues with guards or rear quarters?
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
-
mrs ratbox
-
parisian62
- Posts: 3997
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
thanks J, Terry and RB replys. Ive still got a long way to go but am doing a little planning ahead
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
i had 3" blocks in the rear of my hg, and when i went for a blue slip i had to take them out...this was in nsw also. he didnt say any thing in about the lowered springs in the front. he just said that the blocks are illegal. but it should be fine for pink slip, depending on your rego bloke.
aidan...
aidan...
i'll get there....
