Page 1 of 1
sound / body deadener ? to use or not
Posted: Mon Dec 15, 2008 9:21 am
by dan-0
just looking for some advice here .. i have recently had some floor pans replaced and i've been told to go over them with sound deadner and that it would'nt hurt to paint over other inside panels / floor sections etc with the stuff . my concern is and i don't know where i heard this is that it is not such a good idea to do this ? what do you guy's rekon ??
Posted: Mon Dec 15, 2008 10:00 am
by Blacky
Wait until Rosco gets hold of this one.....
Posted: Mon Dec 15, 2008 10:05 am
by dan-0
really ? why ? .. sounds like i should wait before going out the shed then .
Posted: Mon Dec 15, 2008 10:10 am
by Blacky
Dan-o , do a search on this forum for POR-15 - Rosco has written a very comprehensive post about treating floors etc using various methods.
All you need to know is in Roscos post
Posted: Mon Dec 15, 2008 10:18 am
by dan-0
cheers mate ... will do !
Posted: Sun Dec 21, 2008 6:55 pm
by rosco
Thanks Blacky,
guess I'd be sued if I were to denigrate that blasted stuff any further than already stressed.....
I like it on roads - not on what travels on them....
If you MUST - and I still do NOT condone it, please, please prepare and seal the metal prior to applying any of it - you will effectively be sealing in any moisture which finds its way under the coating - and it will!
PM me if you want my sorry little story - all thirty something years of it.....
I have a lot of "new" metal in my old bus because of this metal cancer causing accelerant......
frats,
Rosco