Page 1 of 1
Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 12:46 pm
by Brett027
Has anyone got a plastic reservoir for the original clutch master cylinder in good condition they are willing to sell? I have a resleeved master but only a metal can which I would like to replace with a clear tank.
Thanks, Brett
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 2:48 pm
by Errol62
Reckon I’ve got a spare one you can have Brett. I’ll have a look.
FB ute fixer upper, EK van on rotisserie
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 3:48 pm
by Brett027
Thanks Clay. I have a few but they are all for a larger diameter thread.
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 4:24 pm
by Errol62
Ok, I'll make sure it is the smaller diameter one.
Sent from my SM-G781B using Tapatalk
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 6:32 pm
by Errol62
All the reservoirs I have are the same thread. They fit this original HD clutch master so these are the later type.
Inside thread diameter is 1 1/8"
Sent from my SM-G781B using Tapatalk
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 7:19 pm
by ardiesse
There was an aftermarket plastic reservoir (PBR?) for the early master cylinders. They're a bit hard to find, though . . .
Rob
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 7:29 pm
by Brett027
Thanks for looking Clay. Hopefully something will turn up. Part of a few changes to Project 2
Re: Plastic reservoir for original clutch master
Posted: Tue Jan 02, 2024 9:44 pm
by Errol62
I guess you are running the earlier type Brett.
FB ute fixer upper, EK van on rotisserie
Inside thread diameter is 1 1/8"
