fbekholden.com

I have Two cars one with hr front and hr discs and one with hr front and torana discs. I tried to swap wheels from car to car and found the torana rims foul on the hr discs. Am i right in thinking the torana discs can be used with standard Holden 13 inch wheels?
Also if my front end is lowered 2 inches and I run standard wheels will 13 80 185 tyres foul?

Hope this isn't as confusing to understand as it was to write.
Rob

Pretty sure Torana discs set your wheels out about 1/2 and inch further than HR, so you will get better clearance.

Thanks Trev I have checked some of the old posts on here and I think I will keep searching for another set of standard width Hr disc brake wheels to be on the safe side. So i have a set of wide (6") hr disc wheels that I would like to swap for a standard width set if anyone is interested. I'm located in Byron Bay Northern NSW.

Rob

G'Day Pero

When I built my first EK I had a problem with Torana Chrome wheels rubbing, we got around it by using spacers that spaced the wheel from the wheel hub I think they were roughly 15mm thick - they were aluminium and were about 150 to 170mm in diametre and had 5 holes to go over the wheel studs.

I think you can still get them from a place like Canterbury Wheels in Melbourne, were illegal years ago.

You could make them yourself if you have a lathe, they should help you get around your disc brake problem.

Regards

James

Thanks James
I ordered some new wheels from ROH.

Rob