fbekholden.com

When I got the EK she was partially disassembled.

Some of the parts I don't seem to have are the all the wires/plugs that go to the taillights, rear indicators and reverse lights.

The globes fit in from behind the lenses, but I can't find any pics in the manual, or on here, of the plug that goes in from the wiring side

I have found the fittings for my front indicators at Autobarn.

Hands up who can help

check the thread in 'electrical' - 'indicators' by FBVAN; if EK fittings are same as FC, these are them . look at the Narva site under 'globe holders', I think you can get the metal-bodied globe holders to suit either single or dual filament globes
hope this helps, jack

Thanks Jack.
I found the front indicators thanks to your help on my other post.

I can't work out if any of the plugs on the Narva site will fit the taillights though.....

http://www.narva.com.au/products/browse/globe-holders

This is what I have........


If the fitting is one of the ones on the above Narva site, which one?
Forgive me if I'm not seeing something obvious

The rest of the fitting should be on your wiring harness.

No, that's my problem.

The guy who I got the car off has cut the wiring off the loom from the dash

I have had to re-do the wiring from the dash.

I haven't ever seen the plugs to know what they should look like

EKSPCL, sorry mate, cant help with that one... it's obviously different to FE/FC taillights

hi ekspcl.i have a old loom here if its any good to you cheers shane

PM sent.

Thanks

I've found one brake light fitting and the two indicators. Thanks again Shane

Now I know what they look like.....



I need another brake/tail light fitting and the two reverse light fittings.

I'll put this to the Parts Wanted section now.

Thanks for the help