Page 1 of 1
Trimatic help
Posted: Mon Mar 28, 2011 12:24 pm
by minifb
Ive got a trimatic in the pig and ive replaced the clip that holds the speepo drive thingy on the shaft at the back of the gearbox three times now.(yes im putting it in the correct way) It only works till i start driving then naps the little clip.. Any help would be great Thanks Mark
Re: Trimatic help
Posted: Mon Mar 28, 2011 12:33 pm
by Aussie Bob
Put in a Hydra-Matic
Re: Trimatic help
Posted: Mon Mar 28, 2011 4:57 pm
by Trev
Is the cable too short (no give)? Also the rear gearbox mount not moving?
Check your engine mount's are not broken.
Sounds like something is moving a fair way to snap that.
Re: Trimatic help
Posted: Mon Mar 28, 2011 10:49 pm
by minifb
Trev wrote:Is the cable too short (no give)? Also the rear gearbox mount not moving?
Check your engine mount's are not broken.
Sounds like something is moving a fair way to snap that.
Thanks trev,gearbox is not moving. i will replace the speedo cable
Cheers Mark
Re: Trimatic help
Posted: Tue Apr 05, 2011 5:01 pm
by Doc Bob
Got it sorted yet
#1 Make sure you have the right matching gears (There are two different drive gears and multiple cable gears)
#2 Make sure that you have the cable retaining plate slotted into the machined groove of the cable drive end.....
NOT.........BOLTED DOWN OVER THE TOP
