Page 1 of 1
celica 5 speed
Posted: Wed Apr 07, 2010 6:41 pm
by blok
Hi there, You have no doubt been through this before ,I have a celica 5 speed w50 gearbox and am not shore what bellhousing to use behind a red202 ,I have the drive shaft so i can use the celica end to make up a shaft ,i have also read that the slave cylinder can be used has any one been through this thanks (Gary)
Posted: Wed Apr 07, 2010 8:57 pm
by Sammy
you need to get a specific bellhousing ... CRS make them as do dellow. get the right bits from them then the original aussie 4 speed hydraulic slave cylinder bolts straight on.
there are also custom yokes you can get for the conversion then you don't need a custom tailshaft .... i had a feeling it was an LH or LJ torana tailshaft is the right length when i did mine!
this is my celica 5 speed with dellow bellhousing
