fbekholden.com

Thanks Wayne.
Tried Clark Rubber the other day but they had nothing close. May try another store if I have no luck with Spectrum Rubber.

Yeah very nice, keep up the great work ... and the posts

I bought my guard rubbers at Clark Rubber , maybe try another store ??

I got the rubber i used from Traralgon clarks, it was a doubled over flat piece that I cut to the shape of the guard.
Traralgon was the only shop that had it.

Spectrum Rubber at Dunheved is now supplied by Rare Spares. They may still still do some of their own rubber products but not sure?

Have a browse through Scotts Auto Rubber...http://www.scottsoldautorubber.com.au/

I bought my 'u' channel for the top of the inner guard at Graham Rubber http://www.grahamrubber.com.au/

Stewart

parisian62 wrote:Spectrum Rubber at Dunheved is now supplied by Rare Spares. They may still still do some of their own rubber products but not sure?

And charge nearly double for the same stuff

Craig Allardyce wrote:Thanks Wayne.
Tried Clark Rubber the other day but they had nothing close. May try another store if I have no luck with Spectrum Rubber.

....................................................................................................................................................................................
Hey Craig .... Got an idea that could work ....get a cheap 700c pushy tube its almost the same size and cut to suit ... .....if ya got hole punches they will do the job just beaut for the holes an will look good .....Fingers

fingers wrote:

Craig Allardyce wrote:Thanks Wayne.
Tried Clark Rubber the other day but they had nothing close. May try another store if I have no luck with Spectrum Rubber.

....................................................................................................................................................................................
Hey Craig .... Got an idea that could work ....get a cheap 700c pushy tube its almost the same size and cut to suit ... .....if ya got hole punches they will do the job just beaut for the holes an will look good .....Fingers

I was gonna mention that trick bill, dunno where I got that from....

Thanks for the advice guys

Front and rear ends ready to fit.

Thanks Tim,
I thought about the change in ride harshness but am prepared to put up with that as opposed to having to change the rubbers when they become displaced and cracked, especially the rear shackle rubbers.
The red nolathane bushes are going to be replaced with Whiteline synthetic elastomer bushes which are quite flexible, I just didn't get around to swapping them over before taking the picture.

Where do you get the elastomer ones from?

Its looking good

Got them from Whiteline. Ordered them direct off the Internet thru their website. Be careful as the front shackle bush is listed as a different type and does not fit FB EK. They have confused them with HD HR and they don't fit. You'll have to order 2 rear shackle kits to ensure you'll have enough for both ends.

Well its been nearly 8 months and she's back on her wheels!!!!.............finally

Looking good mate