Remounting guards

Post by **Blacky** » Thu Oct 22, 2009 11:33 am

I will be doing this shortly and I need the rubbers that sit on top of the subframe , I THINK they are available by the metre from Clark Rubber - someone on here had the correct part number to order them - Parisian62 , was it you ?

Stygian · Post by **Stygian** » Thu Oct 22, 2009 11:36 am

I'd like the answer to this question too...

parisian62 · Post by **parisian62** » Thu Oct 22, 2009 11:43 am

No sorry wasn't me Blacky. I was planing to buy some same profile rubber channel and punch out the holes....but if they can be ordered I'm interested too...

Trev · Post by **Trev** » Thu Oct 22, 2009 1:14 pm

I bought a few meters of rubber channel that fit neatly over the edge of the sub frame, made a series of pie cuts to get the shape and then punched the holes that was required, pretty easy.
Never looked into getting new reproduction rubbers, never entered my mind

, Trev

.

Post by **Blacky** » Thu Oct 22, 2009 1:50 pm

Was that from Clarks Trev?

Trev · Post by **Trev** » Thu Oct 22, 2009 5:43 pm

Post by **Blacky** » Thu Oct 22, 2009 11:38 pm

Will check them out tomorrow - cheers.

Stygian · Post by **Stygian** » Wed Oct 28, 2009 1:29 pm

Did you have any luck at Clark rubber Blacky? Eager to find out. Thanks, Andrew.

Finny · Post by **Finny** » Wed Oct 28, 2009 5:39 pm

I'm interested in these also.

Any pictures of the rubber profiles, and/or final look after holes cut etc, would be appreciated.

Trev · Post by **Trev** » Wed Oct 28, 2009 10:37 pm

Finny wrote:I'm interested in these also.

Any pictures of the rubber profiles, and/or final look after holes cut etc, would be appreciated.

No pic's sorry, why do you care what they look like when they are never going to be seen? as long as they work

, Trev

.

Post by **Blacky** » Thu Oct 29, 2009 5:22 am

Yep , bought the rubber at Clarks , got one that fits over the top of the subframe and some 1mm flat for the back edge of the guard, cost just over $20 I think.

Finny · Post by **Finny** » Thu Oct 29, 2009 3:08 pm

Trev wrote:
Finny wrote:I'm interested in these also.

Any pictures of the rubber profiles, and/or final look after holes cut etc, would be appreciated.
No pic's sorry, why do you care what they look like when they are never going to be seen? as long as they work , Trev .

Just wanted to see which ones to buy.
My old ones had disintegrated, so I don't know what they look like.

Post by **Blacky** » Fri Oct 30, 2009 3:17 am

Will get a pic for you over the weekend Finny.

Stygian · Post by **Stygian** » Tue Nov 03, 2009 7:50 am

Hey Blacky, do you have a pic handy of the rubber you bought from Clarks? Like Finny, mine crumbled when I took my guards off...

Cheers, Andrew