Dizzy installation problems

stafkel · Post by **stafkel** » Sun Sep 20, 2009 8:41 am

I am trying to install a Schorcher electronic dizzy in the grey but can not get it to engage the oil pump slot, I have tried all suggestions in the previous post but still no luck, any avdice will be much appriciated.

Craig · Post by **Craig** » Sun Oct 04, 2009 10:00 pm

I found when I fitted the scortcher to mine I had to keep fitting and removing the dizzy and turning the shaft one tooth at a time to chase the oil pump drive aroud to the right position I hope that makes sense alternativly a long screwdriver can be used to rotate the oil pump drive

And if you are still running a coloum shift it is a fine line in getting the modual housing to clear the gear selectors while shifting (allowing for engine movment under load) and clearance between the side plate and vacume advance unit (it is possable I was being over cautious

stafkel · Post by **stafkel** » Mon Oct 05, 2009 8:37 pm

Thanks for the advise I will give it a go when I get home, I have a five speed box so clearence will not be a problem.