ahh not sure mate , I dont want pin holes that turn into repairs , I will be putting enough heat and tension into the panel just to weld it in position .
I think Ill just keep my fingers crossed and wait for a good one ,
thanks very much though Stuart
A contact No for RUSTRITE in sydney
-
parisian62
- Posts: 3997
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
No worries. It's there if you need it.
Stewart
Stewart
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer