tin mastercylinder resoviours

mrs ratbox · Post by **mrs ratbox** » Mon Dec 29, 2008 10:38 pm

does anybody have any tips on how or if you can refurbish the inside of tin mastercylinder resoviours

rosco · Post by **rosco** » Tue Dec 30, 2008 1:41 pm

Hi Mick,
yes - but I've just about worn out this old thread....

you could give it the POR 15 treatment - brake fluid will do nothing to hurt this stuff and it will stick really well to any rust inside - make sure you use the Marine Clean prior - it should get anything the POR doesn't want to stick to....

just my thoughts...

frats,
Rosco

Thommo · Post by **Thommo** » Tue Dec 30, 2008 3:08 pm

How would HPC coating them go?
Just a thought.

mrs ratbox · Post by **mrs ratbox** » Tue Dec 30, 2008 4:11 pm

thanks i'll look into those ideas
cause the way the will look i thought tin resoviours would look good and i have a few around

Devilrod · Post by **Devilrod** » Wed Dec 31, 2008 9:42 am

Maybe a dip in a molasses bath, then use Rosco's tip. Should make them like new.

mrs ratbox · Post by **mrs ratbox** » Wed Dec 31, 2008 12:35 pm

does anybody know wher i can find the formular for the molasses mix
have to try just filling them with molasses mix don't want the outside to look good

(AUST)Mod · Post by **(AUST)Mod** » Wed Dec 31, 2008 12:41 pm

http://www.moreg.org.au/dissolving_rust.htm

There you go old chap

Down the bottom of the page.

Devilrod · Post by **Devilrod** » Thu Jan 01, 2009 9:44 am

ratbox wrote:have to try just filling them with molasses mix don't want the outside to look good

Oh yeah, oooooppsss...

Thanks Austmod for the link I lost my last one.