Any one run a holley blue on a wagon?

FCCOOL · Post by **FCCOOL** » Tue Jun 24, 2008 8:56 pm

I have a Fc but all the same in this area.i have a exhaust up each side of the tank, i was thinking of running it behind the rear wheel well but it will get pretty dirty there.

Trev · Post by **Trev** » Wed Jun 25, 2008 4:56 am

Could you make a sheild to cover it? Something easy to remove, incase of repairs. Trev

.

Devilrod · Post by **Devilrod** » Wed Jun 25, 2008 12:35 pm

What about in front of the tank and between the diff, maybe just to one side?

mattymartin · Post by **mattymartin** » Wed Jun 25, 2008 3:57 pm

hey guys,

whats a "HOLLEY BLUE"...

matty martin

Trev · Post by **Trev** » Wed Jun 25, 2008 4:17 pm

Elec Fuel pump

FCCOOL · Post by **FCCOOL** » Wed Jun 25, 2008 6:40 pm

Devilrod wrote:What about in front of the tank and between the diff, maybe just to one side?

that would work but my exhuast splits into two and wraps around the back of the tank leaving no room.

Craig · Post by **Craig** » Wed Jun 25, 2008 6:41 pm

Used to run a mallory pump on one of my old 4X4s just cable tied a bit of 2mm rubber over it not to tight so air would still circulate around it kept it fairly clean even with the abuse

Devilrod · Post by **Devilrod** » Wed Jun 25, 2008 8:35 pm

FCCOOL wrote: that would work but my exhuast splits into two and wraps around the back of the tank leaving no room.

Bugger! What about the inside of the sill in front of the wheel arch? Fuel line has to run there anyway.

FCCOOL · Post by **FCCOOL** » Thu Jun 26, 2008 10:26 pm

I'll have a look, it probably isnt deep enough.

Sammy · Post by **Sammy** » Fri Jun 27, 2008 2:23 pm

but the pump can be run on its side can't it ... so have the bottom of the pump up against the inner sill and the cylindrial bit pointing in towards the tailshaft.