Strath Swap 2024

[Errol62]

I’m going to try and get rid of all this.


Wish me luck.


Sent from my iPhone using Tapatalk

[Blacky]

How much for the old blue ute ????

[briby]

"How much for the old blue ute ????"

[Errol62]

Sorry, but the bus is needed to pull my rusty excuse for a trailer to the Swapmeet.


FB ute fixer upper, EK van on rotisserie

[ardiesse]

Clay,

If you could put the wiper motors, FB/EK brake shoes, and the partial Stromberg aside, I'd like them.
Do you have any FB/EK front brake backing plates?

Rob

[Errol62]

No front backing plates sorry Rob. All went to Patrick 62 ute I think. I did put that stuff aside for you already, didn’t I?


FB ute fixer upper, EK van on rotisserie

[Errol62]

Early on the frog


Sent from my iPhone using Tapatalk

[Errol62]

Where is everyone?
It’s 6:30 already


Sent from my iPhone using Tapatalk

[60Special]

Nice one Clay, you should get a bit for that bonnet bar on the Ute.

[Errol62]

The ute got most of the attention Trev. Numbers were down due to Bathurst etc.

I met Russel Cooper finally. Another bloke 14k into a grey build. Sold two fuel pumps $20 each then bought one for $5, etc, etc. Trailer looks much the same as when I set out, bugger it. None of this is coming in the shed. Except all the ice new bits I bought.


Sent from my iPhone using Tapatalk

[Brett027]

Russell Cooper is a top fella. When he lived near Sydney he supplied lots of bits for Wilma. Including A,B and C pillars so I could see what they looked like complete.

[FireKraka]

Hey Clay how good are the fb park light/blinker surrounds

[Errol62]

One is not too bad I think Neil. Not a set. I’ll send it your way?


FB ute fixer upper, EK van on rotisserie

[Errol62]

Russell Cooper is a top fella. When he lived near Sydney he supplied lots of bits for Wilma. Including A,B and C pillars so I could see what they looked like complete.

Seems really nice Brett.


FB ute fixer upper, EK van on rotisserie

[axeman]

Hi there errol62,
You don't happen to have any Top windscreen stainless joiner/cover or a corner stainless that I can cut to make one
Cheers Axeman