Air bags

[Jars44]

Can anyone tell me or inform me if u can put airbags on fb panel van as would like to see how much it would cost thanks guys

[Blacky]

Yes you can do it bu tto get it legally done is not cheap

[Devilrod]

Just about any car can be air bagged, just make sure it's done by a shop that will get it engineered and signed off as part of the installation. Choose wisely as to who you get too do it. Poor work will cost you in the long run and there are a few around at the moment who shouldn't be doing what they do.....

[Jars44]

Is there any one in ballarat /Geelong or melb that does a good job
And thanks guys for your help

[WayneXG95]

It's like over capitalizing on a house.
Where do you draw the line on how much you put into a project?
Can I suggest ya do a budget on a BIG piece of paper.
Then I bet ya don't do it...

But is does look really cool I can understand that..

[wot179]

Be aware that to get it right on the deck you will need tunnel and rear rail mods, as well as signifigant mods to the front end.

If you just replace the springs with bags it wont go down very far at all.

[wot179]

http://www.fbekholden.com/forum/viewtop ... it=airbags

[makntracks]

It's like over capitalizing on a house.
Where do you draw the line on how much you put into a project?
Can I suggest ya do a budget on a BIG piece of paper.
Then I bet ya don't do it...

But is does look really cool I can understand that..

Do your budget, then Double it...

[Devilrod]

I know of two I wouldn't use in Two of those areas as they don't use engineers. Maybe give Air Ride a call. They had a big stand at the Kustom nats just last weekend.

http://air-ride-suspension-supplies.myshopify.com

[Mick Jagger]

front dropped spindles,lowered springs
rear pump up shocks with no bump stops and 75mm blocks
any lower and youll have to cut stuff
cutting stuff is fun,and one can Never be to low,goodluck

[Blacky]

cutting stuff is fun,and one can Never be to low,goodluck

True and true