new pipes fish tails

NoMAD · Post by **NoMAD** » Tue Sep 16, 2014 3:26 pm

sweet!

Cheers
Nathan

Harv · Post by **Harv** » Tue Sep 16, 2014 5:33 pm

I really, really want a set of those fishtails for the EK wagon. I even have flame throwers to go with them (special western Sydney mug lair NASCO option pack)

Only drama is that I need the fishtails to suit 2.5" OD pipe... can only find them to suit 1.75". Seems a shame to run decent pipes (from a worked SBC) then neck the exhaust down at the tip. I doubt you can get a full 0.75" of flare out of them with a pipe flare mandrel... even if you could grab them without marking them.

Anyone seen them to suit bigger bore pipe?

Cheers,
Harv (here fishy fishy fishy........).

gazrat · Post by **gazrat** » Tue Sep 16, 2014 8:19 pm

my mate makes them but not cheep

Harv · Post by **Harv** » Wed Sep 17, 2014 9:43 am

Cool - can you post or PM his contacts please?

Cheers,
Harv

bootlegger · Post by **bootlegger** » Wed Sep 17, 2014 9:19 pm

I had them on a harley but I cant remember the size of the pipe.

Harv · Post by **Harv** » Thu Sep 18, 2014 12:46 pm

Harley ones seem to be 1.75".

This is closer to what I want... the pipe is not really restricted by the "tail", but still has the "fin"":
http://www.ebay.com/itm/221544217912?it ... 23&vxp=mtr
Only drama is that they are 3.75" ID... I'd need a 15mm concentric spacer to suit my 2.5" pipe. It's look a bit funny from side-on under the rear quarter.

Hoping that Gaz' mate can make me up a pair to suit 2.5". Just need the contacts.

Cheers,
Harv

fbekholden.com

new pipes fish tails

new pipes fish tails

Re: new pipes fish tails

Re: new pipes fish tails

Re: new pipes fish tails

Re: new pipes fish tails

Re: new pipes fish tails

Re: new pipes fish tails