G'day, I was hoping someone would have some tips or photos on the best way to attach the metal/stainless steel weather strips to the roof of an EK Station Wagon.
Also, where can I get the clips that hold it on?
Much appreciated.
Help with weather strip attachment needed
-
Walla Pete
- Posts: 16
- Joined: Thu Oct 24, 2013 7:03 pm
- State: NOT ENTERED
- Location: Grafton, NSW
-
parisian62
- Posts: 3997
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
Re: Help with weather strip attachment needed
Hi Pete
check out http://www.fbekholden.com/forum/viewtop ... =23&t=8183
and http://www.fbekholden.com/forum/viewtop ... &start=690 Lots of tape and patience. The triangular piece goes on first and then the stainless that runs over the top of the doors fits over the small tabs of the triangular piece. Then the rear section.
regards
Stewart
check out http://www.fbekholden.com/forum/viewtop ... =23&t=8183
and http://www.fbekholden.com/forum/viewtop ... &start=690 Lots of tape and patience. The triangular piece goes on first and then the stainless that runs over the top of the doors fits over the small tabs of the triangular piece. Then the rear section.
regards
Stewart
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer