Hi .Finally got my seats reupholstered and wanting to know the best way of mounting them.The commodore seats were on alloy spacers but these HR ones are totally different.Am going to try and use at least one pair of the original mount holes but will need spacers and spreader plates.Any one got any advice?
Thanks Mick
Fitting buckets in EK
-
wickedq400
- Posts: 40
- Joined: Mon Mar 21, 2011 6:45 pm
- State: NOT ENTERED
- Location: South West Victoria
Re: Fitting buckets in EK
Hi Mick, I had some HR seats in my sedan and had to make mounts for the inside runners to go over the floor hump.
I got a set of plates made to go under the floor to bolt into also.
Sorry no pic.
I got a set of plates made to go under the floor to bolt into also.
Sorry no pic.
[img]http://i47.photobucket.com/albums/f177/trevwood/WOOFTOsmall.jpg[/img]
Woofto Car Club Member No3
Woofto Car Club Member No3
-
Matthew4655
- Posts: 29
- Joined: Tue Aug 28, 2012 10:20 pm
- State: QLD
- Location: Hervey Bay, QLD
Re: Fitting buckets in EK
Could you make and weld brackets to the floor pans and bolt the seats to the brackets?
Before laying carpet of course.
Before laying carpet of course.