vr wiring loom

[stubby]

can anyone help. im putting a vr statesman wiring loom in my ute and was wondering if anyone knows how to bypass the diff sensor wiring because im changeing the diff with a volvo diff. any help please
stubby

[Bigbird]

http://www.caenterprises.com.au/

Is probably a good resource for that fiddly electrical stuff.

I believe that the sensors going to the diff are for ABS which in the VR ran through the BCM (Body Control Module) and is not an essential component as the VR ECM (Engine Control Module) runs independently.

Once again I believe that the the two units need each other from the VTII onwards when the Gen III was introduced, but this mob actually make a bypass loom.

But, based on public opinion, very easy for me to be wrong.

[stubby]

thanks for the help if thats the case it makes the job a little easier