Page 1 of 1

Distributor NEEDED ASAP

Posted: Wed Feb 03, 2010 2:55 pm
by J
Mine is absolutely rooted.
I think I need an electronic blue motor distributor which apparently is a hell of a lot better than the basic red motor ones.

Leigh and Brodie tuned up the EK on Monday night and got it running perfectly, unfortunately that only lasted a day and the new points they put in are already starting to burn, now its missing beats at low revs.

So, I have been told dont drive it because if it konks out it could be for good. And cos I drive pretty far to work everyday its not a very good idea.

PLEASE, if you know of one or have one in good condition and dont want an arm or a leg for it call me on 04205129878 or contact me on the forum.

Cheers
Jay
PS: Huge thanks to Leigh and Brodie for helping me out on Monday night Very Happy

Posted: Wed Feb 03, 2010 5:44 pm
by vmx-mxr
J

You may as well try fitting a new condenser which should go along way to stopping the points burning out. They cost bugger all and are easy to get.

Dave Mac :D

Posted: Wed Feb 03, 2010 6:13 pm
by Sputzwagon
..also check you have your Ballast Resistor wire connected too J...without it you'll fry points and coils too!!

Scotty.

Posted: Wed Feb 03, 2010 10:26 pm
by J
Had a new condenser put on not too long ago, but in general there is too much play in the dizzy and the base plate is bad too.

dizzzzzzzy

Posted: Thu Feb 04, 2010 10:11 pm
by DA FLETCH
hello. :) i have one out of my red 202 if that helps till you can buy one ....can post asap......... 8)

Posted: Fri Feb 05, 2010 1:50 am
by J
thanks mate, but I am really chasing an electronic blue motor dizzy.
I may have sourced one :)