Page 1 of 1
Schorcher Dizzy instalation HELP
Posted: Sat Jan 02, 2010 9:14 am
by stafkel
Been trying to install a new dizzy (Schorcher)I can not get it to sit flush on to the block it will not drop straight in and there is a 5mm cap between the dizzy and block. The oil pump slot is not an issue as the oil pump as been removed, I tried moving the dizzy a tooth at a time but still no luck I can't even get the old dizzy back in same drama, any help will be much appricated.
totally frustrated
Posted: Mon Jan 04, 2010 6:22 pm
by Craig
Here is a pic of mine installed
is the gap larger than that if not then it is OK
I would refit the oil pump before fitting the dizzy that way you can tell if it is in properly
Posted: Thu Jan 07, 2010 11:24 pm
by stafkel
Thanks Craig
the gap is about the same, the car is running fine starts a lot quicker/easier with the electronic dizzy
cheers
Posted: Fri Jan 08, 2010 4:27 pm
by Craig
no worries mate
best mod to any old engine is a high energy ignition cold weather starts are a breeze