fbekholden.com

Hi all , I am in need of the number for a Rustrite , He is/was a guy that delivered rust repair sections to sydney , Wollongong.

He may even supply rare spares

Have misplaced his number and cant track him down.

Harko, I've been trying ring that guy for months, his mobile is disconnected, no other contact numbers. So don't know whats happened to him.

Well Ive got great news for you .
Rustrite ph 0414478052
Hes delivering a front left and two rear floorpans to me at the desalination plant tomorrow I guess Ill be busy on the coup over the weekend , the tunnel turns up tuesday ..

Hi Harko,

Can you tell us more abour rustrite? Have they got a shop? Do they press their own panels/rust sections? Are they cheaper than rares?

Stewart

Hi Harko,
Does this guy make lower rear Quarter Rust repair panels?

Regards
Swivel

Today I bought two rear and a front left for $85 each delivered .
His price seems a little exorbident to previous purchases .

Im pretty sure he supplies rares but these seem a thicker grade of steel than rares ones .but still inherit the flaws.

His van had all makes of cars signwritten on it so I presume he does most makes and one offs.

Swivel I actually asked that exact question and he said he could make it but didnt stock it ..

thanks Harko. Are you still chasing a rear door? what side?

I am , a right rear , Im heading up to the blue mountains early tomorrow then back to colyton , if you have a nice clean one buzz me 040 333 0880 and Ill see if I can swing across town .

I've got a few doors down the back of the shed. will check it out in the morning and let you know.

Thanks Stuart

does rustrite do complete panels (guards ect) or just rust repair sections? sounds good that they're a thicker grade steel though.

I have one. It looks pretty clean. Has been resprayed at some time and the trim holes welded up. There are 2 small rust spots both about the size of 5c piece. Have left my mobile number on your mobile.

forgot to add...it has no glass.

Harko,
Could we see a photo of the repair sections (floors). I have bought several types and hate the pressings cause they just don't fit right including rares. I found a nos rear right and it was a perfect fit. Still have the rear left to do but not happy with the pans I have bought.

Regards Greg

They are identical to rares in that respect , the rears seem ok so far but the fronts look hammered into shape in areas where I know they are pressed , Ive fitted them before aswell and I know exactly where you are coming from .
I acheived the best results by teck screwing the floorpan into position - pulling the offset swages to where they should be then cutting along inbetween the screws and welding , then removing the screws cutting and welding the rest , then welding up the screw hole .
Hmm sounds like alot of extra work to utilise a poor design huh.

Hi Harko,

Did you want that door?

regards
Stewart