Page 1 of 1
tin mastercylinder resoviours
Posted: Mon Dec 29, 2008 10:38 pm
by mrs ratbox
does anybody have any tips on how or if you can refurbish the inside of tin mastercylinder resoviours
Posted: Tue Dec 30, 2008 1:41 pm
by rosco
Hi Mick,
yes - but I've just about worn out this old thread....
you could give it the POR 15 treatment - brake fluid will do nothing to hurt this stuff and it will stick really well to any rust inside - make sure you use the Marine Clean prior - it should get anything the POR doesn't want to stick to....
just my thoughts...
frats,
Rosco
Posted: Tue Dec 30, 2008 3:08 pm
by Thommo
How would HPC coating them go?
Just a thought.
Posted: Tue Dec 30, 2008 4:11 pm
by mrs ratbox
thanks i'll look into those ideas
cause the way the will look i thought tin resoviours would look good and i have a few around
Posted: Wed Dec 31, 2008 9:42 am
by Devilrod
Maybe a dip in a molasses bath, then use Rosco's tip. Should make them like new.
Posted: Wed Dec 31, 2008 12:35 pm
by mrs ratbox
does anybody know wher i can find the formular for the molasses mix
have to try just filling them with molasses mix don't want the outside to look good
Posted: Wed Dec 31, 2008 12:41 pm
by (AUST)Mod
http://www.moreg.org.au/dissolving_rust.htm
There you go old chap
Down the bottom of the page.
Posted: Thu Jan 01, 2009 9:44 am
by Devilrod
ratbox wrote:have to try just filling them with molasses mix don't want the outside to look good
Oh yeah, oooooppsss...
Thanks Austmod for the link I lost my last one.