sump gasket
Posted: Thu Nov 13, 2008 9:47 pm
do you need to put any silicone on them
regards fat
regards fat
Page 1 of 1
Posted: Thu Nov 13, 2008 9:59 pm
I just use gasket goo on one side to hold it in place.
Posted: Thu Nov 13, 2008 11:19 pm
I pretty much do as DR said.
I find if you coat both sides of the gasket it tends to get a bit too "squishy" and can move around a bit too much when tightening.The only spots where I would use goo on both sides would be where two gasket ends join and butt together.
I'd use goo on the sump side and leave the pan side dry.
I find if you coat both sides of the gasket it tends to get a bit too "squishy" and can move around a bit too much when tightening.The only spots where I would use goo on both sides would be where two gasket ends join and butt together.
I'd use goo on the sump side and leave the pan side dry.
Posted: Fri Nov 14, 2008 2:53 am
I used it on both sides, marvelous stuff 
, Trev 
.
, Trev .Posted: Fri Nov 14, 2008 11:01 am
I used the GOO to fill my holes in my radiator at Yamba and its still going!!!
Cheers Theo Z...................
Cheers Theo Z...................