fbekholden.com

Help , i have taken old springs out when I jack up lower control arm, i cant bline it ut with the bush. When I jack up the arm it keeps on moving across about 1" ..
any ideas

Sorry Al but not sure what you mean by "i can't bline it ut with the bush".Not trying to be a smart a#*e but just don't know what you mean.

All done FBM. the wishbone wouldnt fit back over the the 2 lugs that are mounted on the either side of the crosmember, had to line up back one first then the front with a lot of persuasion.
Ended up using a siscors jack on an angle from the back of the drum to the floor jack to line the wishbone with crosmember.
I hope the springs drop they were 2" lowered only droped 15mm

Any advise of a better way ?
Cheers
AL

The springs/front end kind of settles a bit after fitting and a few runs so you'll find the front end may lower a bit more over time than the 15 mm that it's dropped so far.Although I'm not sure whether it will drop another 35 mm to give you the 2 inch drop the manufacturer has said .

See how it goes, the worst thing that can happen is you have to remove the spring and cut off another 1/2 to 1 coil from the spring to get your 2 inch drop your after .