fbekholden.com

Hey all,

I was just wondering if anyone could give me the run down on what it takes to convert HR stud pattern to HQ and an approx Price??

I currently have a hr cross member in the old girl and hr discs and drums on the back.

Cheers
Robbo

I don't know about about the rear, but up front you can fit HQ-HZ stubs, discs and calipers without too much trouble to the HR front-end.

I believe that to do this you would simply unbolt the stub axles and bolt on the HQ-WB type up front, then the rear redrill the stud pattern, why not try an expert like Hoppers Stoppers (in Melbourne) for exact requirements

here is the link

Cheers
Matt