Approval through....Yehaaaa!
Posted: Tue Mar 11, 2008 10:11 pm
The TAC (RTA) has approved V8EK4US! it's all go now as per original specs other than a small tyre width variation.......I originally had 195 (on 15x6 Convos) up front with a seriously tubbed rear end running 15x10 Convos and 295's in the application. I have had to reduce the size variation to less than 70% between front and back. Thanks to Spyder I have secured the 15x6 convo's and 225/60's (new) that he has and this brings the whole project fully street legal with the 6/71 blown 350 SB and a 9" shortened by 160mm to keep the 15x10's under the original guards and match up with the tubbing. 
Yehaa! break out the tools....we're finally getting to work on this baby!
Now what was that I needed.......grinder, welder, oxy, cutting discs, tape measure...............................ohh yeh, and an imagination to go with the mission! After seeing Mal's project the mind is running wild....well done again Mal!
cheers, V8EK4us.
Yehaa! break out the tools....we're finally getting to work on this baby!
Now what was that I needed.......grinder, welder, oxy, cutting discs, tape measure...............................ohh yeh, and an imagination to go with the mission! After seeing Mal's project the mind is running wild....well done again Mal!
cheers, V8EK4us.
