Gearbox Crossmeber for Hydramatic

strogger · Post by **strogger** » Fri Oct 05, 2007 6:15 pm

Can anyone please tell me if there is supposed to be a crossmember at the rear of a Hydramatic transmission?
I can see the flange and bolt holes on trans but nothing coresponding in car to facilitate crossmember fitment.

Also how much shaft should show from trans output to first uni?
Mine seems excessive at approx 3 inches.
(Never thought i'd say that.

)

Thanks in advance.

Graypower · Post by **Graypower** » Sat Oct 06, 2007 12:43 pm

does not have cross member /3 inches sounds right

strogger · Post by **strogger** » Sat Oct 06, 2007 2:37 pm

Thanks for that.
Was a little worried i maybe missing an important peice.