Page 1 of 1
Trim clips and end bits
Posted: Wed Jul 28, 2021 7:39 pm
by steveo
Hi ,
Isolating in the garage for the next couple of weeks so may finally make some progress..
Looking for advice on stainless trim attachment . I have clips from rare s , but they don't seem to be a good fit. Quite possible it is operator error .
Do you just give it a whack ?
And what is the end clip... larger hole //?
Advice appreciated
Thanks ,
Steveo
Re: Trim clips and end bits
Posted: Wed Jul 28, 2021 8:07 pm
by funkyscooter
I got these after guessing from what was left on the car - don't know what was holding the trim on.
- IMG_8721.JPG (603.04 KiB) Viewed 572 times
Look a bit large as its closer to the camera. Not sure if they will work, and a long way off finding out
Re: Trim clips and end bits
Posted: Wed Jul 28, 2021 8:36 pm
by steveo
Thanks , I have some of those and my best guess at fitting is as picture ..
. it doesn't seem very robust..
Re: Trim clips and end bits
Posted: Wed Jul 28, 2021 11:25 pm
by Errol62
The ones on your car look about right to me Stevo, but I’m no expert on Specials. I was going to get the ones Scott posted to fit the commercial/standard guard spears as I reckon they matched the originals on mine. Ended up re using original ones in the end.
FB ute fixer upper, EK van on rotisserie
Re: Trim clips and end bits
Posted: Thu Jul 29, 2021 7:42 am
by Blacky
That looks about right
Re: Trim clips and end bits
Posted: Sat Jul 31, 2021 11:58 am
by steveo
Thanks .. all good
Re: Trim clips and end bits
Posted: Sat Jul 31, 2021 12:33 pm
by In the Shed
good job
Re: Trim clips and end bits
Posted: Sat Jul 31, 2021 1:06 pm
by Errol62
Second that. Looks very straight.
FB ute fixer upper, EK van on rotisserie