Page 1 of 1
B Pillar
Posted: Fri May 22, 2020 12:20 am
by Clinker42
Guys, I seen a pic in one of the members posts that looks like he removed the strip on the outside of the b pillar that fills the gap between the doors. I couldn’t see what he did to fill in the gap that it left. I presume he just welded in a strip to one or both of the doors.
Has anyone else done this, if so could you please post some pics.
Thanks Trev
Re: B Pillar
Posted: Fri May 22, 2020 7:21 am
by EK283
Hi Trev,
Iv'e done it and its just a strip welded to the edge of the front doors.
- WP_20170707_16_38_33_Pro.jpg (117.58 KiB) Viewed 395 times
- WP_20170708_10_53_33_Pro.jpg (124.49 KiB) Viewed 395 times
- WP_20170715_16_43_20_Pro.jpg (1.2 MiB) Viewed 395 times
Greg
Re: B Pillar
Posted: Fri May 22, 2020 6:48 pm
by Clinker42
Hey thanks Greg, hope you do t mind but I’m going to do that as well, but I’ll make the corner square.
Thanks Trevor
Re: B Pillar
Posted: Fri May 22, 2020 7:08 pm
by Errol62
Bet you wanted the gap central Greg, but back door edge would foul on pillar. Subtle but cool mod guys.
FB ute fixer upper, EK van on rotisserie
Re: B Pillar
Posted: Fri May 22, 2020 8:33 pm
by ardiesse
Trevor,
If you make the bottom corners square, the front door will be fine; but the back door will foul on the B-pillar when you open it.
Rob