Page 1 of 1
Guard trims
Posted: Fri Nov 08, 2019 4:26 pm
by FJWALLY
For the single stainless guard trims for utes and vans and some sedans what is the correct orientation - small surface up or down - Ive seen it put on both ways but which is correct?
Sent from my iPhone using Tapatalk Pro
Re: Guard trims
Posted: Fri Nov 08, 2019 5:34 pm
by gpi
like your bumperettes?
Re: Guard trims
Posted: Fri Nov 08, 2019 5:37 pm
by FJWALLY
Sorry no front guard spears - on the sides that follow the guard line - long skinny ones
Sent from my iPhone using Tapatalk Pro
Re: Guard trims
Posted: Sat Nov 09, 2019 4:29 pm
by Errol62
Small up Rob
Sent from my SM-A705YN using Tapatalk
Re: Guard trims
Posted: Sat Nov 09, 2019 6:41 pm
by FJWALLY
yeah thanks mate - looks like they have put mine upside down
hopefully can flip them without issue
Re: Guard trims
Posted: Sat Nov 09, 2019 7:48 pm
by Errol62
Never mind. Didn’t seem to bother the judges at Mudgee........
FB ute fixer upper, EK van on rotisserie
Re: Guard trims
Posted: Sun Nov 10, 2019 12:48 am
by Blacky
FJWALLY wrote: Sat Nov 09, 2019 6:41 pm
yeah thanks mate - looks like they have put mine upside down
hopefully can flip them without issue
I think that was commented on in Mudgee come to think of it .
Re: Guard trims
Posted: Sun Nov 10, 2019 7:45 am
by FJWALLY
Thanks Blacky - The same holes were used as original so it should only be a matter of flipping them over - just have to not scratch the paint - lol
