fbekholden.com

Can the rubbers for the wires going through back of the Bucket be purchased? if yes where from pls as I am in need of two ASAP

Have a look on the Danchuk website for 55-6-7 Chev ones, reckon they would do the job
https://www.danchuk.com/ItemForm.aspx?Item=402

Thanks Blacky - they are pretty similar to what the wiring guys have done minus the grommet that goes into the bucket - I might just try and save the grommet and use heat shrink over the wires - funny how this one rubber was overlooked by rare spares

Not familiar with your model but Rares do list these, is this what your after?

https://www.rarespares.net.au/rarespare ... s-fe-ek-pr

That oughta do it !

Or are they these ones?
Cheers,

John

Yeah thats them John - could not find them on rare site and I bought the full rubber kit so will hit them up as should be included.
Thanks for that
Rob

ehsv6 wrote: Wed Jan 23, 2019 4:52 pm Not familiar with your model but Rares do list these, is this what your after?

https://www.rarespares.net.au/rarespare ... s-fe-ek-pr

Just get a John to spin you up a pair. Honestly though I just used Nitto tape Wally. Good stuff


Sent from my iPad using Tapatalk

Sorry I gave credit to John but should have gone too ehsv6 - thats the correct tube set I wanted

Went to Rares and apparently it's not included in the full rubber kit - why they could not answer so if you want them need buy separately for 42$ a pair.
Has only been an option for past 6 months apparently - good to see they are thinking of us.

Reason I wanted them is they do provide a very good water seal into the bucket

Thanks everyone.
Rob

ehsv6 wrote: Wed Jan 23, 2019 4:52 pm Not familiar with your model but Rares do list these, is this what your after?

https://www.rarespares.net.au/rarespare ... s-fe-ek-pr

My thanks as well. I’ll be grabbing a pair.

I’m not sold on lashing out on the rubber kit myself. I prefer to get the bits I need as I need them. Some bits can be reused but it depends if you want the car to look brand new, or are happy with maintaining the old car appearance as I am.


Sent from my iPhone using Tapatalk

Yes I went the full kit as mine were pretty much destroyed from 50+ years of mid NSW heat and dust - none survived the removal process so it was the simplest choice - the only part I may not use is the screen rubbers as the installer seams to prefer the competitors version

Errol62 wrote: Thu Jan 24, 2019 11:54 am My thanks as well. I’ll be grabbing a pair.

I’m not sold on lashing out on the rubber kit myself. I prefer to get the bits I need as I need them. Some bits can be reused but it depends if you want the car to look brand new, or are happy with maintaining the old car appearance as I am.


Sent from my iPhone using Tapatalk