fbekholden.com

Wanting to buy a set of front seat runners ...anyone got some ......Thanks Fingers 0409253202

Fingers,

I've got a manky front seat frame here that has already begun donating springs to various retrim projects. Describe to me the exact runner bits you need and I'll take some photos. Yours for free if the bits are any good.

Cheers,
Harv

Onya Harv

Orright Fingers, I took a look in the spare parts department. Had to take a stick with me to fight off the redbacks.

The two front seat runners are there, and will unbolt from the bottom of the frame. There is also the connecting wire that goes in between the two runners if you need it. They have surface rust. The drivers side must have been sitting in a puddle - both the front and rear "feet" are there, but the bottom 5mm is corroded (paper thin or only just there). A bit of work to use them.

If you want them, PM me an address and I'll throw them in the post, gratis. OK too if you want to hang out for a better set.

Cheers,
Harv

Bill if its any help I've got a set here you can have. Might save Harv the cost of postage. I'm sure I'll be swinging past your way in the next month or so. I'm also going to the Churchill show and shine next week so I might be able to arrange something then with potential return travellers to Melbourne.

Craig Allardyce wrote:Bill if its any help I've got a set here you can have. Might save Harv the cost of postage. I'm sure I'll be swinging past your way in the next month or so. I'm also going to the Churchill show and shine next week so I might be able to arrange something then with potential return travellers to Melbourne.

-------------
Thanks mate that would be much appreciated .....send me us mob no and I,ll give ya a call .....thanks Fingers 0409253202

Harv wrote:Orright Fingers, I took a look in the spare parts department. Had to take a stick with me to fight off the redbacks.

The two front seat runners are there, and will unbolt from the bottom of the frame. There is also the connecting wire that goes in between the two runners if you need it. They have surface rust. The drivers side must have been sitting in a puddle - both the front and rear "feet" are there, but the bottom 5mm is corroded (paper thin or only just there). A bit of work to use them.

If you want them, PM me an address and I'll throw them in the post, gratis. OK too if you want to hang out for a better set.

Cheers,
Harv

_____________________
Thanks for the offer Harv....looks like Graig Al has got me covered ....thanks again Mate.....Fingers

No drama.

Cheers,
Harv