fbekholden.com

Hi All
I am after one of the little chrome strips that are under the windscreen on FB anyone got one that they would like to see come back to life one of mine is missing a pin



Thanks
BILLY

I think I have a couple in the shed I didn't use on my ute
I'll check for you

Regards

Kel

Kel -- did you have any luck ???
BILLY

If you can't get one Billy, Call Shane he fixes the broken pins and dose a great job with chrome..
Mail down and mail back!

Electroplating Technology
Electroplating Service

Address: 2/67 Thurralilly Street, Queanbeyan East NSW 2620

Phone:(02) 6297 0535

Cheers Wayne

Hi Billy

Finally got to get out to the shed after work tonight. I do have a set, 2 have only one pin and the other had both pins missing but you are welcome to them if they are any use to you.
PM me your address and I wil post them to you

Regards
Kel

Kel --PM sent
Thanks for the offer but I think I will try and find some with two pins. Still looking anyone ?
BILLY

Got 3 here BB, but not chromed. Came of an FB Van. Have all the pins.

Hi all
Sorted thanks it was easy really what I did was find a pop rivet that stem was close to the pin size knock the pin out of the pop rivet had to drill it out a little and glued the pop rivet onto the little bit of the pin that was left drilled out the hole so it was a tight fit then knocked it into the hole you could use a little glue if you liked but mine was a tight fit and I figure that it only sits there that it wouldn't need it hope this makes sense and helps someone i am really surprised how simple it was but of course you have to have a bit of the pin left to glue to. Not bad for a printer I think anyway
BILLY