HEATER MOUNTING
Posted: Fri Apr 17, 2015 10:05 pm
I have a ridgee didge warmride heater i,m about to fit , it seams that its only held in with two screws on each side up to the plenum vent , is it that simple ????? NEV 
Nev,
Most only have the screws holding them. There was however a bracket available that braces the whole assembly - see page 45 of the Guide for a drawing if you want to make one:
http://www.fbekholden.com/forum/viewtop ... 29&t=12061
Cheers,
Harv