Page 1 of 1

FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Thu Aug 01, 2013 7:55 pm
by adell'e 1969
G'day I saw a fb sedan in a picture that had bullet type looking rear lenses. Does anyone know if they still are available ??? sorry my description is pretty shit , mick jaggers custom sedan seems to have that type lights on it ???

cheers Tony 0467 685257

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Thu Aug 01, 2013 11:06 pm
by Mai Ki-Ki
http://www.classicplastic.com.au/catego ... ategory=10

Reminds me I need to get some too.......!

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Fri Aug 02, 2013 1:23 pm
by Devilrod
Mai Ki-Ki wrote:http://www.classicplastic.com.au/catego ... ategory=10

Reminds me I need to get some too.......!
I run a set of these on mine. You need to do ne of two hings when you get a set unless they've changed since I bought mine. Either buy longer screws or sand the base down to thin it out as the plastic is thicker than the originals. Mine are around 9 years old now and no issues with fading either.

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Fri Aug 02, 2013 9:50 pm
by adell'e 1969
Thanks Very Much Guys I will order a set this weekend and get some longer screws and I will let you know how they fit :thumbsup: :thumbsup: :thumbsup: Cheers again Tony

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Sat Aug 03, 2013 9:18 am
by Devilrod
I should add I sanded mine down. It doesn't take long just rwrap some sand paper over a flat surface if you do plan to thin them down.

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Sat Aug 03, 2013 10:48 pm
by Doc Bob
The only mods I had was to slightly enlarge the bolt holes.
Other than that, very happy with their parts. Also fitted the Wagon rear Number Plate lenses, they were a perfect fit :D

Highly recommend their gear to anyone. :thumbsup:

Re: FB/EK SEDAN BULLET TYPE REAR LIGHTS

Posted: Sun Aug 04, 2013 4:36 pm
by Stationsedanman
Had to enlarge the screw holes and file the edge of the lense to make mine fit too. Bit disappointing when you fork out that much cash. Had to use longer screws too, as previously mentioned. Not sure if they've fixed this in the last 18 months since I fitted mine. :esad: