Need something for your daily driver or to finish off that project?
Moderators: reidy , Blacky
kel3629
Posts: 95 Joined: Fri Aug 24, 2012 7:48 pm
State: VIC
Location: Shepparton
Post
by kel3629 » Sun Sep 09, 2012 8:50 pm
Looking for section of front floor pan (total car width) to replace the flat sheet shown in the photo
Thanks
Kel
Attachments
front floor left a.jpg (23.07 KiB) Viewed 612 times
crupi
Posts: 18 Joined: Tue Jun 10, 2008 10:28 pm
State: NOT ENTERED
Post
by crupi » Tue Oct 09, 2012 12:16 am
Hi there how'd you go with the floor section have you found one?
[img]http://web.aanet.com.au/~digitalslr/new/EK_small.jpg[/img][img]http://web.aanet.com.au/~digitalslr/new/EK_sedan_small.jpg[/img][img]http://web.aanet.com.au/~digitalslr/new/Joe's_Wagon.jpg[/img]
kel3629
Posts: 95 Joined: Fri Aug 24, 2012 7:48 pm
State: VIC
Location: Shepparton
Post
by kel3629 » Tue Oct 09, 2012 9:12 am
Nothing at this stage
I have ordered new rear sections but will only be using the base of them in the back. I am hoping the leftovers may be able to be used in the front
crupi
Posts: 18 Joined: Tue Jun 10, 2008 10:28 pm
State: NOT ENTERED
Post
by crupi » Thu Oct 11, 2012 6:31 pm
See how you go! Your in shepparton? If so I am as well might be able to fold something up for you!
[img]http://web.aanet.com.au/~digitalslr/new/EK_small.jpg[/img][img]http://web.aanet.com.au/~digitalslr/new/EK_sedan_small.jpg[/img][img]http://web.aanet.com.au/~digitalslr/new/Joe's_Wagon.jpg[/img]