head gasket
Posted: Mon Aug 01, 2011 7:56 pm
can you still buy copper head gaskets for grey motors ?
any help would be
cheers dave
any help would be
cheers dave
Page 1 of 1
Re: head gasket
Posted: Mon Aug 01, 2011 10:02 pm
We used to get red motor ones from BERCO in the ACT ???? from memory - it was years ago , dont know if they are still going .
Re: head gasket
Posted: Mon Aug 01, 2011 10:30 pm
Just out of curiousity mate, why you after a copper one?
Cheers Muza
Cheers Muza
Re: head gasket
Posted: Tue Aug 02, 2011 11:53 pm
almost time to bolt the norman on the engine 
i know they are a bit thicker might help reduce compression a bit
and hold out a bit longer than the stock ones
just a thought
i know they are a bit thicker might help reduce compression a bit
and hold out a bit longer than the stock ones
just a thought
Re: head gasket
Posted: Wed Aug 03, 2011 5:46 pm
ACL will cut you one or Ridgecrest (0359814334) they have several different thicknesses available .they are cut from a single layer not like the old original layed and pressed copper gaskets of old Cheers Gary
Re: head gasket
Posted: Wed Aug 03, 2011 6:49 pm
nice work thanks 4 the contact
Re: head gasket
Posted: Mon Aug 08, 2011 10:17 am
There is one on eBay at the moment I think.