fbekholden.com

Devilrod wrote:If those bumperettes aren't rusted through yet grab them, they're not easy to find.

Yeah DR I was thinking that'd be the case. They'll be getting stored away for sure.

Blacky wrote:Spotto a sunvisor ..................

Are u after one blacky? I've actually got one with me FB, unfortunately the guy had it sittin on the back floor for a while and it ended up a bit out of shape. Not sure whether it'll be going back on or not...

FireKraka wrote:Thanks for that Tyson I will keep looking the guy I bought it from says he may have one but might be rough so I will just have to sort it.

Mate if one of the ID plates is in reasonable nick from one of the utes I could probably do with one as the guy also has now told me that the shell is missing it's and he does not know if it is in one of the boxes, willing to pay just PM me mate.

Regards
Neil H

Yeah I'll have to check Neil, depends if I may need need them for a future project. I assume they'd be hard to find now..?

Tyson wrote:

Blacky wrote:Spotto a sunvisor ..................

Are u after one blacky? I've actually got one with me FB, unfortunately the guy had it sittin on the back floor for a while and it ended up a bit out of shape. Not sure whether it'll be going back on or not...

No mate, but they are in demand, I think I have run out of them now .....

Thanks Tyson would appreciate it but understand if you need them.
Do you also have a UTE?

Regards
Neil H

Keep the sun visor.

FireKraka wrote:Thanks Tyson would appreciate it but understand if you need them.
Do you also have a UTE?

Regards
Neil H

Nah I don't Neil, not yet! Leg room is an issue for me in the older utes anyway, even in the HZ I struggled to stretch me legs out. But I wouldn't wanna rule anything out completely! Haha

Your right mate never count out anything but come on mate spare me one ha ha
I am jealous at how good your sedan looks I have an FC Sedan that I am just finishing but my EK ute is just a shell so long way to go.
Regards
Neil H

Ahaha we'll see. Yeah thanks mate, There's still a bit that needs doin on it but might drive it around a bit before I start overhauling' it. U gonna put up a pic of your FC? haha

Tyson I only joined the forum a couple of days ago I dont want to get kicked off for putting up a photo of my FC ha ha

Regards
Neil H

Neil,
there's a section called "other cars of interest" - you can pop up as many pix of your FC in there - no problems.

frats,
Rosco

Thanks Rosco when I figure out how to add photos I will put some up of the FC I have the same problem on the FE FC Forum it is always difficult. I have added an avatar showing the EK Ute shell I have bought and my obvious starting point.

Regards
Neil H

upload them to Photobucket - then copy/paste to your thread - that's how I do it... until I find something better/easier..


frats,
Rosco

G'day guys, back from a few weeks off down on the coast. Pretty happy with how the FB went! Also met a mate of an old mate who tuned the old grey up a little to get it runnin real smooth AND gave me a spare wheel too! Not to mention that everywhere I drove it people stopped to look twice, smiled, waved and gave compliments, old and young, they all appreciated it.

So as u know, I've decided on keeping this old girl original, (which I'm sure excites a lot of u) So I'm hoping you guys may be able to help me out in finding the original door trims to replace those funky replacements that are on there now.

The trim code is "329-886" which from what I found on a thread on trim codes is "Amulet & Scarab Green with Stardust Grey Bolsters".

Also what is used to hold on the badges/stars etc that have the pins that poke through the panel? Do they use some type of clip? One of the stars on the front guard was hangin right out, nearly falling off, so I pulled it out to find 2 straight pins and nothin on the backs of them..?

Any help would be much appreciated!

Cheers,
Tyson

Tyson,
Spotted this on Gumtree, business called "Just Early Motor Trimmers"

We have Genuine seat patterns from Ek through to Hz. GTS, SS, premier, Gtr, Belmont and so on. Made to order, Headlinings, Carpets, Kick panels and genuine machine pressed doortrims. 38 years self employed in Melbournes northern suburbs and recently opened Just Early's Motor Trimmers. Please call for a quote, our work does not disappoint. Photos upon request.

http://www.gumtree.com.au/s-ad/campbell ... 1037815463

Might be worth a call?

Regards
Stephen