Page 4 of 4
Posted: Fri May 22, 2009 8:06 pm
by Devilrod
Heater hose or Temp gauge, hard to tell when your holding it so close to the camera!
Posted: Fri May 22, 2009 8:15 pm
by jazzar02
Devilrod wrote:Heater hose or Temp gauge, hard to tell when your holding it so close to the camera!
Fixed that up devilrod, Here are a few from different angles
Posted: Fri May 22, 2009 9:06 pm
by jazzar02
So does anyone know how i can plug the hole up ?
Posted: Fri May 22, 2009 9:10 pm
by Devilrod
Aftermarket Temperature gauge or buy a proper bung (brass if possible as it wont rust).
The only gauges you'll ever really need for a red are temp and oil pressure ones..
Posted: Fri May 22, 2009 9:12 pm
by jazzar02
Devilrod wrote:Aftermarket Temperature gauge or buy a proper bung (brass if possible as it wont rust).
The only gauges you'll ever really need for a red are temp and oil pressure ones..
So i could just go down to the local performance shop and pick up a speco or other brand tempreture gauge?
And hopefully it will fit into the hole.
Posted: Fri May 22, 2009 9:24 pm
by jazzar02
For a oil pressure gauge where would that go on the eninge?
Posted: Sat May 23, 2009 7:35 am
by Trev
Oil pressure sender is down the side near the distributor, Trev
.
Posted: Sat May 23, 2009 12:30 pm
by Devilrod
SPL camry wrote:So i could just go down to the local performance shop and pick up a speco or other brand tempreture gauge?
And hopefully it will fit into the hole.
Yep!
Posted: Sat May 23, 2009 6:21 pm
by jazzar02
ok so i think i found a adaptor that should fit the aftermarket thermo housing, Here is a link to it so if anyone has a after market one on there red they could tell me if this is the right size?
http://www.autometer.com/cat_accessorie ... spx?vid=66
Also i am thinking about getting these 3 gauges and having between the bonnet and windscreen. here is a link to these aswell
http://www.autometer.com/cat_gaugedetai ... 696&sid=61
Posted: Sat May 23, 2009 9:38 pm
by mrs ratbox
SPL camry wrote:
Also i am thinking about getting these 3 gauges and having between the bonnet and windscreen.
once again an idea best kept for the camry
Posted: Sat May 23, 2009 9:40 pm
by jazzar02
haha ok but i keep telling people we rolled the camry over on it's side so it's no more, i got a commodore now lol
But anyway how do you think i can install the gauges without ricing it out ?
Posted: Sat May 23, 2009 10:50 pm
by mrs ratbox
under or in the dash
