Page 4 of 4
Re: wiper motor
Posted: Wed Nov 28, 2018 9:25 pm
by EK283
Guys/Gals,
Just about to dive into this myself, a question in relation to the EK crank onto the VN wiper motor how is this achieved ?
I haven't got a wiper motor yet so was curious is it splined and tapered and what needs to be done to get it to fit ?
Thanks Greg
Re: wiper motor
Posted: Thu Nov 29, 2018 7:15 am
by EK283
No need to respond to this,
I have done some reading last night ( I need to pay attention to links ) and have it sorted'.
Thanks Greg
Re: wiper motor
Posted: Mon Oct 25, 2021 11:26 am
by FbSTDwagon
This has been a good read and will help me this afternoon, but I have some broken bushes on the pivot shafts and don’t seem to be able to find replacements anywhere.
Does anyone know where to get these bushes?
Re: wiper motor
Posted: Mon Oct 25, 2021 11:43 am
by Blacky
dont know about those ones, maybe cut a strip of rubber and glue together ???
Re: wiper motor
Posted: Mon Oct 25, 2021 12:02 pm
by Brett027
Maybe cut out from an old rear spring shackle rubber? Or a big dob of silastic
Re: wiper motor
Posted: Mon Oct 25, 2021 1:31 pm
by FbSTDwagon
Both good ideas fellas, I reckon I’ll wrap some rubber round it and glue it in with silastic!
Job done!!!
Re: wiper motor
Posted: Mon Oct 25, 2021 2:37 pm
by Errol62
Tractor tube. It’s thicker.
FB ute fixer upper, EK van on rotisserie
Re: wiper motor
Posted: Mon Oct 25, 2021 3:31 pm
by FbSTDwagon
Quick solution…
22mm grommet with some creative cutting.
Seems to fit well so job done.
Re: wiper motor
Posted: Mon Oct 25, 2021 6:53 pm
by Blacky
spot on
a smear of rubber grease and call it done .
Re: wiper motor
Posted: Wed Oct 27, 2021 3:41 pm
by mph
Mine I went into rare spares and found a &*#@ rubber in one of the small packs that was a close fit and then some minor trimming.
Sent from my SM-G970F using Tapatalk
