Re: Moon fb
Posted: Wed Nov 30, 2011 6:54 am
Be patient steve just gathering parts at the moment maybe after next weekend ill post some more pics
regards fatboy
regards fatboy
Steve
Page 4 of 5
Re: Moon fb
Posted: Wed Nov 30, 2011 9:12 am
Come on Fatty, where are the pics???
Steve
Steve
Re: Moon fb
Posted: Mon Dec 05, 2011 11:56 am
Waiting!!!! I'm almost finishing painting the home...and will be ready to 'line out' the two tone on the ute, Fat. 
Scotty.
Scotty.
Re: Moon fb
Posted: Thu Feb 16, 2012 2:05 am
Keen for updates 
Re: Moon fb
Posted: Thu Feb 16, 2012 4:17 pm
2nd that
Re: Moon fb
Posted: Thu Feb 16, 2012 7:06 pm
some updated pics for everyone.I have installed a southern chassis works front end .Ive got to make some new engine mounts as the steering shaft goes through the engine mount as it sits.Ive got the motor sitting on a piece of 35 mm timber.I would like to move the motor back another 15mm so will have to modify drivers side alittle bit .Ive done the passenger side will take pics on weekend
regards fatboy
Re: Moon fb
Posted: Thu Feb 16, 2012 8:24 pm
Mummy, why has that nice ute got daddy's keg in its mouth...hewey wrote:
Re: Moon fb
Posted: Sat Feb 18, 2012 4:53 pm
Oh HA HA...it is to laugh!MeFB wrote:Mummy, why has that nice ute got daddy's keg in its mouth...
Scotty.
Re: Moon fb
Posted: Sat Feb 18, 2012 4:54 pm
This thread delivers!
Re: Moon fb
Posted: Thu Feb 23, 2012 12:56 pm
what about using an engine plate to mount it Fat?
Re: Moon fb
Posted: Thu Feb 23, 2012 8:19 pm
Looking good mate,
You'd reckon for the money those frontends are, that a bit more homework to allow for both steering and engine mounts would have been done. Bloody shame, it'd probably have great clearence if you put the grey back in it.
You'd reckon for the money those frontends are, that a bit more homework to allow for both steering and engine mounts would have been done. Bloody shame, it'd probably have great clearence if you put the grey back in it.
Re: Moon fb
Posted: Fri Feb 24, 2012 3:02 pm
Still contemplating a engine plate will do some work on it tomorrow night hopefully
Re: Moon fb
Posted: Fri Feb 24, 2012 8:22 pm
Could you make an engine mount boss out of flat plate, boxed with crush tubes that has a hollow underneath to allow steering clearence? Excuse the bodgey drawings but something like this.
Or an engine mount boss like on a CRS front end, but built to allow the clearence required, that I have highlighted in pink.
Or an engine mount boss like on a CRS front end, but built to allow the clearence required, that I have highlighted in pink.
Re: Moon fb
Posted: Fri Feb 24, 2012 9:15 pm
that's pretty much how my mate has done a few now, flat plate bent that the engine mount actually sits on withtube welded to underside for bolt to go through
Re: Moon fb
Posted: Mon Jun 11, 2012 4:47 pm
Heres my engine mounts mate ....these are SCW standard sbc mounts ..borrowed Heaths jig and welded them straight in after trimming to the correct length.....the motor dropped straight in ....heaps of clearance for the steering shaft but the steering column end is another story ......and 15 mm clearance from fire wall on the right hand bank ...how about some more updated photos mate ........Fingers
