fbekholden.com

Ahhh if only I had seen that before would have saved me all the leg work... Looks nice and neat!

Cheers
Nathan

well back from another lengthy overseas holiday and now its full steam ahead on the FB... the old boy gather some bits to start on the exhaust and we got stuck into it yesterday

i'll let the pictures speak for themselves... he's been a bit handy the old bloke i have to give him credit for the leg work here







drivers side started as well



just tacked up at the moment but its a good start

cheers
Nathan

Any progress is good progress. They look good.

Yep - build a few sets, reckon you will be able to sell some ..................

Well after picking around with the drivers side, and the steering shaft we finally have 2 log headers... off to a contact to have them fully tigg'd up properly...

just need to put a bit of a scallop in the side support structure but nothing to hard...









Cheers
Nathan

Very nice - you DID make a set for me as well didn't ya maaaaattteee ?????

looking nice, what size main pipe did you use? I am looking to do the same arrangement but with the pipe stubs angled towards the back of the car (between the heads and main pipe)

Blacky wrote:Very nice - you DID make a set for me as well didn't ya maaaaattteee ?????

well they are sitting on your heads

Coopa... basically just followed this guide...

http://www.fbekholden.com/forum/viewtop ... ers#p68907

if you do a search for Log Headers a few come up on here...

Cheers
Nathan

i did the scollop thing on the chopped ute so we could get decent clearence
just be sure to brace it with a 5mm minimum thickness material
my engineer did not have a problem with me doing it this way




V

CHOPPED wrote: just be sure to brace it with a 5mm minimum thickness material
my engineer did not have a problem with me doing it this way

hey Chopped just curious why 5mm?

my engineer has said hes happy with me replacing it with the same thickness as a minimum based on a simple \__/ scallop shape?

Cheers
Nathan

Ask 10 engineers and you will get 10 different answers NoMad ..........

nothing to fancy... but got my headers back, just need to be cleaned up and will send them off to be coated at some point... plan is to start work on the sump this weekend, pretty much the last major hurdle before a few holes to wled up and then it can start getting all the bits together for the body shop.



Cheers
Nathan

Nice work mate.

Hi Nathan, can I ask where you got your exhaust manifold plates & mandrels from? I like the look of your set-up. Cheers, John