fbekholden.com

L

Ok


FB ute fixer upper, EK van on rotisserie

I’m not great at paints I just teach myself where I can I used to do a lot of hydrographics which is very 2pac dominant. I mainly take advice from the paint reps at the shops. Any advice is always welcome.

Me too. I’m very lucky to have found a retailer that is an ex-painter. Good on you for having a go.


FB ute fixer upper, EK van on rotisserie

That’s exactly what I have found too!

Yeh I am trying to do as much as I can on this it won’t be perfect but at least I can say I did it all

Hydrographics Dave - thanks for that! just spent an hour on YouTube. Can't believe I never heard that term before. Was a bit of a "so that's how they do that" moment for me.

[mention]funkyscooter [/mention] you just got me intrigued and wow. That’s is awesome Dave. Are we going to see any bits of your build in Hydro.


Sent from my iPhone using Tapatalk

Belly760 wrote: Sat Jul 24, 2021 9:33 am Are we going to see any bits of your build in Hydro.

The whole car!!! Seriously though, already got me thinking about the steering wheel. Carbon fiber? Woodgrain? Pearl? Fully sick carbon fiber instrument cluster.

Good stuff mate.

Just remember the poison isocyanate, that mask you got on wont save you.

At a minimum it needs to be carbon filtered, Sunstrom do a good mask but its just the minimum.

The isocyanate is in most hardeners so read the tins and be very careful.

Greg

I used to do a fair bit but YouTube is the biggest lie. It’s so much harder and more involved than what you see. Thinking of doing some of my engine covers but we will see when the time comes to it I’ll post some photos of what I have done

Here is some I did . Welding helmet was for my dad

This is what I’m up for

Fair few holes and tricky pieces

Just found this patch job tape and bog over it

Bit of fun in that! Was just fabricating one of those today.