Re: Weber Carbies
Posted: Fri Sep 21, 2012 5:23 pm
Hi Mick,
The guy who made the manifold was Pete Mallaby (FCHOON) on the FEFC forum http://fefcholden.org.au/forum/index.ph ... file;u=125
Send him a PM, really helpful & does a relly neat job. Not sure on cost yet.
Fingers,
Finally got the car running OK, I used a 50 idle jet in the primary side & we put on a gas tester & found the main in the primary was way too lean, causing it to starve. Out with the jet drills & just made it bigger. the jet had 135 on it & we took it out to around 160. Still a little hesitation when going to secondaries, but nothing too bad. When I have the spare cash I might get it dyno-tuned.
Hope this helps,
Dean.
The guy who made the manifold was Pete Mallaby (FCHOON) on the FEFC forum http://fefcholden.org.au/forum/index.ph ... file;u=125
Send him a PM, really helpful & does a relly neat job. Not sure on cost yet.
Fingers,
Finally got the car running OK, I used a 50 idle jet in the primary side & we put on a gas tester & found the main in the primary was way too lean, causing it to starve. Out with the jet drills & just made it bigger. the jet had 135 on it & we took it out to around 160. Still a little hesitation when going to secondaries, but nothing too bad. When I have the spare cash I might get it dyno-tuned.
Hope this helps,
Dean.