fbekholden.com

its just a dual 7 inch booster and billet master and yes we made up both sets of headers because my bro is doing a 308 fb ute as well in townsville

Someone outthere should make a batch of 304/308 headers. I reckon they would sell a few consitering what the exhaust blokes are quoting!

DOLLER wrote:Someone outthere should make a batch or 304/308 headers. I reckon they would sell a few consitering what the exhaust blokes are quoting!

it's hard to do cause not all engines sit in the same position, in my 308 ute we had a tunnel ram with the same scoop and the scoop was maybe an 1" or 2" higher than this one therefore the engine must have sat much lower, they don't look like they're real hard to make though a couple of people on here have done them

yea Mick there a piece of piss too make just buy blank flanges and get a bit of 2 1/4 pipe bent need two 1 5/8 mandrel bends for the ends a bit of 1 5/8 straight pipe and an 1 5/8 whole saw and a spare head to weld them up on helps

Looks good mick, nice work there

ditto,coming along nicely

Just got a set of Sams scuff plates does a great job well worth the money

That is very cool, I really like that radiator!

How good is that Telstra rope, who doesnt know someone that knows someone that gives them that rope?

hi she's looking good do have any info on the rack including pics think of doing a v6 transplant in EK and dont really want to spend 2.5 k on gardiner kit

mickhrt wrote:Just got a set of Sams scuff plates does a great job well worth the money

He does make some pretty good suff plates and are a great fit as well.

Utes coming along very nicely indeed.